Motorola Confidential Proprietary
A920/A925Handset Test Commands
2 - 6
Preliminary
0000b (0x00) 0 parse error (no data follows): invalid data length for command
0001b (0x01) 1 parse error (no data follows): inadequate security level for command/parameter
0010b (0x02) 2
parser error (no data follows): command/parameter not supported for current protocol
(CDMA, GSM, TDMA)
0011b (0x03) 3
parse error (no data follows): command/parameter not supported for current mode
(normal, test mode, handset test mode)
0100b (0x04) 4 parse error (no data follows): unsupported/invalid opcode
0101b (0x05) 5 parse error (no data follows): unsupported/invalid parameter for opcode
0110b (0x06) 6 command response: generic success (no data follows)
0111b (0x07) 7 command response: generic failure (no data follows)
1000b (0x08) 8 command response: data follows
1001b (0x09) 9 unsolicited/multiple response: data follows (sequence tag is 0)
1010b (0x0A) 10 error: couldn’t allocate memory
1011b (0x0B) 11 error: internal task error
1100b (0x0C) 12 error: Test Command task timed out waiting for response from another SW component
1101b (0x0D) 13
CDMA: parse error (no data follows): command/parameter not supported for current sub-
mode TDMA: command not supported in current Call Stack Test Mode
1110b (0x0E) 14
error: length specified in command header greater than length received by transport
layer
1111b (0x0F) 15 error: irrecoverable error; phone state has been lost. Phone is being powered down
Opcode
(Hexadecimal)
Opcode
(Decimal)
Response Field Definition
Table 2. Standard Response Codes
To Next Page
Loading...
