Motorola Confidential Proprietary
Manual Test ProceduresLevel 3 Service Manual
3 - 11
Preliminary
Parameter
Low
Limit
High
Limit
Unit
WCDMA Power Out 20.5 21.5 dBm
Non-signalling Test Procedures
(WCDMA)
To perform non-signalling test procedures, the user is
required to be familiarized with sending test commands
to the phone under test. The test commands can be
sent using the Handset test command interface or
through a computer. Please refer to section,”Handset
Test commands,” for details on how to send test com-
mands through phone keypad entry. Also, refer to,
“Computer Test Commands,” for details on how to send
test commands through the computer.
In order to successfully send test commands to the phone
under test, the phone needs to be in suspend mode.
Follow the listed procedure to place the phone in sus-
pend mode.
Handset Test Commands
54 ok Suspend
Radio Comm Test Commands
Click AT+MODE then SUSPEND
(Serial Only)
Click PST Initialize and click SUS-
PEND when initialization is complete
(USB Only)
Hardware Requirements
Refer to page 2 for a list of Hardware. Refer to Figure
4 for a configuration illustration.
Table 9. WCDMA TX Power Output
Software Requirements
Handset Test Command
• No software needed
Computer Test Command
• Radio Comm (latest release)
Verify TX Power Output (WCDMA)
Verify the TX Power output by initiating the commands
in this section. Verify that the results fall within the fol-
lowing limits.
Handset Test Commands
54 Suspend
3086 W_CARRIER
Field 1 9750 Set Channel
Field 2 0 Enable Carrier
Field 3 023 Max Power Out
Field 4 027 Max TX Power
Field 5 206 Min TX power
Field 6 002 PN9 Data pattern
Field 7 1 Enable spreading
Field 8 01 Long scrambling
Field 9 000 SF256, Slot format 0
Field 10 000 SF256, Slot format 0
Field 11 000 Channelization Code
Field 12 000000000 Scrambling Code
Note: Enter 1 in field 2 to disable carrier
Non-signalling Test Procedures (WCDMA)
To Next Page
Loading...
