Motorola AP-650 Series User Manual

Introduction
3
1.5 Features
• One RJ-45 connector
• LED indicators
• Safety wire tie point
• Slots for wall mounting
• Clips for mounting on a suspended ceiling T-bar
• Lock port for Kensington® style Security Lock
The AP-650 Thin Access Point has one RJ-45 connector supporting an 10/100/1000 Ethernet port and
requires 802.3af-compliant power from an external source.
The AP-650 Thin Access Point comes in both single and dual radio versions both supporting 802.11a/
b/g/n.
The Thin Access Point contains runtime firmware which enables the unit to boot after either a power
up or a watchdog reset. The runtime firmware on the Thin Access Point and the firmware downloaded
from the switch can be updated via the Ethernet interface from the Wireless Switch.
NOTE When operating in a Gigabit Ethernet environment CAT-5e or CAT-6 cable
is required for Gigabit operation.

Motorola AP-650 Series Specifications

General

Brand	Motorola
Model	AP-650 Series
Category	Wireless Access Point
Language	English