Motorola APX 1000 - Page 871

Troubleshooting Tables: List of Board and IC Signals 7-31
Note:
* PU = Pull Up
* PD = Pull Down
tdi JTAD Data in from JTAG
box to Controller
Y19 Input Input Pull-
down
nemu0 "Emulation pin 0, not
used, pulled high on
PCB
"V16 I/O Input Pul-
lup
nemu1 "Emulation pin 1, not
used, pulled high on
PCB
"W17 I/O Input Pul-
lup
Table 7-10. Overall GPIO pin functions (Continued)
Signal Name Description
Pin
or
Ball #
Active
State
SW Initialized HW Reset
Direction
*
PU State Direction
*
PU
or
PD