EasyManua.ls Logo

Motorola ASTRO 25 GTR 8000 - Page 107

Motorola ASTRO 25 GTR 8000
309 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Port /
Type
Device it connects to:
Port /
Type
Description
dios, or with a mix of
QUANTAR
®
stations:
Site Controller module B
port,
RJ-45
NOTICE: The length of the cable
between the site controller and
the base radio should be no
greater than 30 ft.
ASTRO
®
25 repeater
site with More than six
GTR 8000 Base Ra-
dios, or with a mix of
QUANTAR
®
stations:
External Site LAN switch
or Site Controller mod-
ule B
LAN port,
RJ-45
IP interface connection to the site LAN
switch port for this channel or connection to
site controller B base radio port for this
channel. An optional SDM RTU device
connects to the site LAN switch that is con-
nected to this port.
RX-A,
BNC
Receive line A BNC RF coax to receive path for antenna A.
RX-B,
BNC
Receive line B BNC RF coax to receive path for antenna B.
This port is used for dual diversity for
TDMA.
Transmit
port, N-
type
Transmit line N-type RF coax to transmit antenna.
Aux Pwr
Output
Comparator or Site Con-
troller
Aux Pwr
Input
Provides secondary power to a convention-
al comparator for a conventional base ra-
dio, or to the site controller in an ASTRO
®
25 repeater site.
Bat Temp,
6-pin
Battery temperature
sensor
Connection to temperature sensor, allow-
ing for temperature compensated battery
charging.
RF Pe-
ripherals
RF peripheral sensor
ports
Antenna relay and presence detect, exter-
nal circulator load temperature (external
wattmeter not supported).
Batt/DC DC power supply or bat-
tery
Batt/DC Input from and output to a 48 VDC power
supply or backup battery. When AC power
is not available, the device switches to op-
erate from a DC source if the optional DC
power (8AWG; length 9 ft), CA01400AA is
ordered and installed. One end connects
into the Batt/DC port and the other end
connects into the DC source. The contacts
are 39-83503N02 (AMP #53880-2), the re-
ceptacle housings are 15-83502N01 (AMP
#53884-1) and the mounting ears are
07-83504N01 (AMP #53887-1).
3084869Y06 cable is used for a positive
ground system. 3084869Y02 cable is used
for a negative ground system.
AC 120/240 VAC power
source.
Input from 120/240 VAC nominal power
source.
MN003286A01-E
Chapter
3: GTR 8000 Base Radio Installation
107

Table of Contents

Related product manuals