EasyManua.ls Logo

Motorola ASTRO 25 GTR 8000 - Configuring the T1-2 R with Talk-Around Option Kit

Motorola ASTRO 25 GTR 8000
309 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
d At the confirmation screen, click OK.
e Click Change to Normal Mode.
The device halts activity in the current mode and switches operation to the requested mode.
f Disconnect the Ethernet cable from the transceiver module Ethernet service port.
g Repeat for each device in the configuration.
A.2.4
Configuring the T1-2R with Talk-Around Option Kit
Prerequisites: Ensure that all required installation procedures have been performed for the base radio
and receiver and that the devices have been powered up.
When and where to use: This procedure is used to configure the WildCard Tables for a T1-2R with
Talk-Around configuration using the Configuration/Service Software (CSS).
Procedure:
1 If necessary, perform the initial configuration for the base radio. See Device Configuration in
CSS on page 134for details.
2 Connect to the Ethernet port on the base radio. See Connecting Through an Ethernet Port Link
on page 140 for details.
3 From the menu, select FileRead Configuration From the Device.
4 From the navigation pane, select Hardware Configuration. Set Station Type [R] to Analog
Only.
NOTICE: When configuring GPW 8000 Receivers, the Hardware Platform [R]
parameter is set to GPW 8000 Satellite Receiver.
5 Set Antenna Relay [R] to Enabled.
NOTICE: Use the default value of 30 msec for the Antenna Relay Delay.
6 From the navigation pane, select WildCard Tables. Click Set to Default to add default
WildCard tables.
7 Click Yes to reset the WildCard Tables to their default structure. The following default WildCard
Tables are created:
NOTICE: WildCard Table numbers are arbitrary and shown for illustration purposes.
Memory size and the number of States and Commands in each table limit the maximum
number of WildCard tables.
Wild-
Card
Table
Descrip-
tion
States and Condi-
tion
Actions Inactions
State Value Com-
mand
Value Com-
mand
Value
1 In-cabi-
net RPT
Input 6 n/a In-cabi-
net Re-
peat ON
n/a In-Cabi-
net Re-
peat
OFF
n/a
2 Rx In-
hibit
Input 7 n/a RX IN-
HIBIT
n/a RX EN-
ABLE
n/a
MN003286A01-E
Appendix A: Conventional
GTR 8000 Base Radio Option Kits
299

Table of Contents

Related product manuals