Figure 54: CSS Login Banner
4.4
Device Configuration in CSS
This section covers configuration of a device using the Configuration/Service Software (CSS).
NOTICE: The IP address for the device is available through a serial port connection in the
Tools → Set IP Address from the CSS menu.
4.4.1
CSS Initial Device Configuration
Process:
1 Perform the following configuration steps that require a serial connection. See Connecting
Through a Serial Port Link
on page 135.
a Set the IP address and paring number of the device. See Setting the Device IP Address and
Pairing Number in CSS on page 137.
b Set the serial security services. See Setting the Serial Security Services in CSS on page 138.
2 Perform the following configuration steps that require an Ethernet connection. See Connecting
Through an Ethernet Port Link on page 140.
a Set the pairing number of the device. See Setting the BR/CM Pairing Number in CSS on
page 142.
b Set the current date and time. See Setting the Date and Time in CSS on page 143.
c Change the SNMPv3 configuration and user credentials on a selected device in the site. See
Changing SNMPv3 Configuration and User Credentials in CSS on page 143.
d Create, update, or delete an SNMPv3 user. See Adding or Modifying an SNMPv3 User in
CSS on page 146.
e Verify the SNMPv3 credentials. See Performing an SNMPv3 Connection Verification in CSS
on page 146.
f Configure Domain Name Services (DNS). See “Configuring DNS in CSS” in the
Authentication Services manual.
g Set the Software Download (SWDL) transfer mode. See Setting the SWDL Transfer Mode in
CSS on page 147.
MN003286A01-E
Chapter
4: GTR 8000 Base Radio Configuration
134
To Next Page
Loading...
