Motorola Canopy User Manual

AP_CMM2 User Manual Pa
g
e 24 of 49
INSTALLATION
The following steps are required to install the Canopy Access Point module(s), the Cluster
Management Module, and the GPS antenna:
• Unpack the Canopy products
• Configuration of the Access Point modules
• Configuration of the Cluster Management Module
• Installation of the Access Point modules, Cluster Management Module, and GPS antenna
• Verification
UNPACK THE CANOPY PRODUCTS
Upon receipt, carefully inspect all shipping boxes for signs of damage. If there is damage,
immediately notify the transporatation company.
Unpack equipment, making sure that all ordered components have arrived. It is recommended that
you save all the packing materials. They can be used for transportation of the equipment to and
from installation sites.
CONFIGURATION OF THE ACCESS POINT MODULES
In all cases, for configuration changes to take effect, the operator must
1. Make the configuration change or changes on a module’s web page.
2. Save the configuration change or changes, using the Save button.
a. Make and Save additional configuration changes if desired.
3. Reboot the module, using the Reboot button.
The configuration changes don’t take effect until the module is rebooted.
The are two methods that can be used to configure each of the Access Point modules. The first
method is to use the
Quick Start feature of the product. For more information on Quick Start see
The Interface Screens. The second is to manually set each of the parameters.
The Access Point module, from the factory, is configured to
not transmit on any frequency. This is
done so that an operator does not accidentally turn on an unsynchronized Access Point module.
An operator will need to verify the following information:
• Will the Access Point module need to generate its own sync pulse or will it receive it
from the Cluster Management Module?
• The operator will assign a RF frequency for the module to transmit.
• The operator may assign value for uplink and downlink bandwidth capping. If the
Access Point module is in a cluster with other modules then this parameters on all
units
must be set exactly the same.
• The operator will assign an IP address to the module for the network it will be installed
on and assign an appropriate subnet mask and network gateway.

Motorola Canopy Specifications

General

Brand	Motorola
Model	Canopy
Category	Control Unit
Language	English