AP_CMM2 User Manual Pa
e 34 of 49
Registered SM Count: displays the number of subscriber modules currently registered to the
Access Point module.
GPS Sync Pulse Status: displays the current status of the type of synchronization the Access
Point module is receiving. There are 3 values that could be displayed:
•
Generating sync
: If the module is set to generate its own sync pulse then this message will
be displayed.
•
Receiving Sync
: If the module is set to receive a sync pulse from an outside source (not
itself) and is actually receiving the pulse then this message will be displayed.
•
ERROR: No Sync Pulse
: If the module is set to receive a sync pulse from an outside
source (not itself) and it is currently not receiving the pulse this message will be displayed.
When this message is displayed the Access Point module will turn its transmitter off so as
to not create any self-interference within the Canopy System.
Radio Slicing Value: displays information to be used be Canopy technical support.
Radio Transmit Gain Setting: displays information to be used by Canopy technical support.
Site Name: displays information relating to the name of the physical module. This parameter can
be set by the operator on the
Configuration
web page. This information is set into the
sysName
SNMP MIB-II object and can be polled via a SNMP management server.
Site Contact: displays contact information for the physical module. This parameter can be set by
the operator on the
Configuration
web page. This information is set into the
sysContact
SNMP MIB-
II object and can be polled via a SNMP management server.
To Next Page
Loading...
Need help?
General
