Motorola CLP series User Manual

PROGRAMMING THE RADIO
THROUGH CPS
20
2. Make sure the radio is turned ON.
3. Once the radio is connected, open the CPS and
select “Read” on the toolbar to get the radio
profile. The CPS allows the user to change
settings, such as General, Audio, Menu,
Channels, Scan List, as well as select
frequencies, PL/DPL codes on each channel.
4. After you change the settings, press “Write” on
the toolbar to save the settings.
For more information on the Computer Programming
Software, please refer to Help menu on the CPS.
Note: (*) CPS Programming Cable (P/N HKKN4025) is an
accessory sold separately. Please contact your
Motorola Point of Purchase for more information.
Factory Default Settings
Your radio is programmed at the factory to the
following settings:
CLP1010 1W UHF 1 CH Radios Default Settings - BRUS
Channel
#
Frequency
#
Frequency
Setting
Code
Value
(Hz)
Band
width
(kHz)
1 2 464.5500 67 12.5
CLP1040 1W UHF 4 CH Radios Default Settings - BRUS
Channel
#
Frequency
#
Frequency
Settings
Code
Value
(Hz)
Band
width
(kHz)
1 2 464.5500 67 12.5
2 8 467.9250 67 12.5
3 5 467.8500 67 12.5
4 6 467.8750 67 12.5

Motorola CLP series Specifications

General

Brand	Motorola
Model	CLP series
Category	Two-Way Radio
Language	English