RADIO CLONING
24
Cloning Radios using the CLP Series Multi-
Unit Charger (MUC) Kit P/N HKPN4007
(optional accessory)
1. To put the source radio into clone mode,
press and hold PTT and the “-” button while
turning the radio ON until you hear the
Cloning Tone and Double Blinking Orange
on the Smart Status Glow.
2. Place the source radio into one of the
charging pockets that has the “CLONE”
label.
3. Turn the target radio ON and place it in the
pairing charging pocket that has the
“CLONE” label and start the cloning process.
4. Press the “Menu” button on the source radio
to start the cloning process. The source
radio generates the start clone tone.
5. Once the cloning is completed, turn the
target radio OFF and back ON again in order
to activate the radio.
6. To clone another radio, repeat steps 3, 4 and
5.
7. To exit clone mode on the source radio, turn
the radio OFF.
Cloning the Radio through a Multi-Unit
Charger
To Next Page
Loading...
Need help?
General
