RADIO CLONING
21
RADIO CLONING
CLONING RADIO SETTINGS
You can copy the CLP Series radio settings from
one radio (the source) to a second radio using the
CLP Series Single Unit Charger (SUC) Kit P/N
HKPN4008 and CLP Series Cloning Cable Kit P/N
HKKN4026 (optional accessory) or CLP Series
Multi-Unit Charger (MUC) Kit P/N HKPN4007
(optional accessory).
A multi-channel radio can be cloned to a single-
channel radio BUT only the first channel will be
cloned. The Multi-Unit Charger (MUC) does not
have to be plugged in for cloning, but both radios
require charged batteries.
CLONING INSTRUCTIONS
Cloning Radios using the CLP Series
Cloning Cable Kit P/N HKKN4026 (optional
accessory)
Source Radio: Radio to be cloned
Target Radio: Radio to which the configuration of the
“Source Radio” will be copied.
Before beginning the cloning process, make
sure you have:
• A fully charged battery on each one of the
radios
• Two CLP Series Single Unit Charger (SUC) Kits
• Both radios are turned OFF
1. Unplug any cables (power supply or USB
cables) from the Single Unit Chargers.
Cloning the Radio through a Single
Unit Charger
To Next Page
Loading...
Need help?
General
