26
CLP REPEATER CAPABILITY:
WORKING WITH RPX
4. Press the “Menu” button on the CLP radio to
start the cloning process.
5. Once the cloning is completed, turn the RPX
OFF and back ON again in order to activate
the radio.
6. To clone another RPX, repeat steps 3, 4 and
5.
7. To exit clone mode on the CLP radio, turn the
radio OFF.
Programming the RPX through a
Multi-Unit Charger
1. Place the CLP radio into one of the charging
pockets that has the “PROG” label indicated.
2. Connect the micro-USB plug of the micro-
USB adapter cable with the RDX Serial
Clone Cable into the micro-USB receptable
charging pockets with the “PROG” label
indicated.
3. Follow steps 4 through 7 under
"Programming the RPX through a Single Unit
Charger" on page 25.
Programming the RPX through a Multi-Unit
Charger
To Next Page
Loading...
