PROGRAMMING THE
RADIO THROUGH THE CPS
English
22
2. Make sure the radio is turned ON.
3. Once the radio is connected, open the CPS
and select “Read” on the toolbar to get the
radio profile. The CPS allows the user to
change settings, such as General, Audio,
Menu, Channels, Scan List, Customized PL/
DPL, Bluetooth
(*)
, as well as select
frequencies, PL/DPL codes on each
channel.
4. After you change the settings, press “Write”
on the toolbar to save the settings.
For more information on the Computer Programming
Software, please refer to Help menu on the CPS.
Note: (*) CPS Programming Cable (P/N HKKN4025) is an
accessory sold separately. Please contact your
Motorola Point of Purchase for more information.
(*)
Bluetooth is available on selected models only.
Factory Default Settings
Your radio is programmed at the factory to the
following settings:
CLP1013 1W UHF 1 CH Radios Default Settings - BRCAN
Channel
#
Frequency
#
Frequency
Setting
Code
Value
(Hz)
Band
width
(kHz)
1 1 458.6625 67.0 12.5
CLP1043 1W UHF 4 CH Radios Default Settings - BRCAN
Channel
#
Frequency
#
Frequency
Settings
Code
Value
(Hz)
Band
width
(kHz)
1 1 458.6625 67.0 12.5
2 2 469.2625 67.0 12.5
3 1 458.6625 71.9 12.5
4 2 459.2625 71.9 12.5
To Next Page
Loading...
