ADVANCED RADIO
CONFIGURATION (*)
28
English
ADVANCED RADIO
CONFIGURATION (*)
(*) Enhancement feature on CLP radios. May not
be available on previous shipping radios.
Advanced Radio Configuration provides you with
the ability to configure the following settings from a
pre-programmed list without the need to use a
computer.
• Channels
• Frequencies
• Codes (CTCC/DPL)
Frequencies allows the user to select frequencies
for each channel. Codes helps minimize
interference by providing the user with a choice of
code combinations that filter out static, noise, and
unwanted messages.
Entering Advanced Radio Configuration
Mode
Before starting, make sure the device is powered
OFF.
Note: For Bluetooth models, make sure the wired
accessory is connected or the Bluetooth
headset is paired before entering Advanced
Radio Configuration Mode.
1. Press the PTT, “+” button and Power button
at the same time and hold for 3 to 5 seconds
until you hear a “chirp” sound and the voice
prompt “Programming Mode”.
Note: The LED Indicator should start blinking a
green heartbeat
.
2. Press the Menu button to select the
settings you want to change:
• Channel (for multi-channel models)
• Frequency
•Code
3. The voice announcements indicate the menu
items and their current settings. To change,
press “+/-” buttons; to go to the next menu
item, press Menu button.
4. To exit the Advanced Radio Configuration
Mode, press and hold the PTT button until
you hear a “beep” sound.
5. Resume normal radio operation.
To Next Page
Loading...
