English
25
RADIO CLONING
2. Plug one side of the cloning cable
microconnector to one Single Unit Charger.
Plug the other end to the second Single Unit
Charger.
Note: During the cloning process no power is being
applied to the Single Unit Charger. The batteries
will not be charged. A data communication is being
established between the two radios.
3. Turn ON the “Target Radio” and place it into
one of the Single Unit Chargers.
4. On the “Source Radio”, power the radio
following the sequence below: Press and
hold the Push-to-Talk (PTT) and the “-”
Button simultaneously while turning the
radio ON until you hear the Cloning Tone
and Double Blinking Yellow on the Smart
Status Glow.
5. Place the “Source Radio” in its Single Unit
Charger with an Audio accessory, then
press and release Menu Button to start the
cloning process.
6. After cloning is completed, the “Source
Radio” will sound either a “pass” tone
(cloning was successful) or a “fail” tone
(cloning process has failed). The pass tone
sounds like a good key “chirp” whereas the
“fail” tone sounds similar to a “bonk” tone.
(A tone will be heard in no more than 5
seconds).
7. Once you have completed the cloning
process, you should turn the radios “OFF”
and “ON” to bring them to normal user
mode (exit “clone” mode).
To Next Page
Loading...
