Phone Programming
27
Pause Digit Entry
When storing a number, you can program your phone so that it will not
only dial a number but also pause and enter another series of numbers
such as a personal identification number (PIN) or password. This
3
Enter the name of the individual you want to store. (Notice, each
key has a number and several letters. To select different letters
on a key, quickly press the key until the desired letter displays.
For example, to enter the letter Y you must press 9 3times
quickly. Also, you can press and hold # to change the case of
the letter you just entered—lower to uppercase and upper to low-
ercase. The default style is uppercase.)
NOTE: Press the left side of lr to backspace or delete a let-
ter. Press the right side of
lr to insert a space.
After you have entered the name, pressounder “Store.”
4
Enter Phone Number displays. Enter the area code and phone
number.
Remember to add plus and pause entries if desired. See “Pause
Digit Entry” on page 27 and “Plus Dialing” on page 35.
Pressounder “Store.”
5
The name and Spd# = displays. The system automatically
assigns a Speed Dial number which you can change by entering
a new number. Pressounder “Store.”
6
Enter PrvtID displays. Enter the Direct Connect Private ID.
Pressounder “Store.” If you do not wish to store a Private ID,
press ounder “Skip.”
7
Repeat steps 2 through 6 to add additional names/numbers.
8
Pressounder “Exit” when you have finished.
To Next Page
Loading...
