SAFETY AND GENERAL INFORMATION
SAFETY AND GENERAL INFORMATION
Product Operation
This section contains important information on the safe and efficient operation of
your mobile device. Read this information before using your integrated multi-service
portable radio.*
When placing or receiving a phone call, hold your radio product as you would a wire
line telephone.
Speak directly into the microphone.
Exposure to Radio Frequency (RF) Energy
If you wear a radio product on your body when transmitting, always place the radio
product in a Motorola approved clip, holder, holster, case or body harness. If you
do not use a body-worn accessory supplied or approved by Motorola and are not
using the radio product in the intended use positions along side the head in
the phone mode or in front of the face in the two-way radio mode—or if you hang
your device from a lanyard around your neck—keep the device at least 2.5
centimeters (1 inch) from your body when transmitting.
Your phone contains a transmiter and receiver. When it is ON, it receives and
transmits RF energy. When you communicate with your phone, the system
handling your call controls the power level at which your phone transmits.
Your Motorola phone is designed to comply with local regulatory requirements
in your country concerning exposure of human beings to RF energy.
ALL MODELS WITH FCC ID IHDT56KQ1 MEET THE
GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO
RADIO WAVES.
Portable Radio Product Operation and
EME Exposure
Your Motorola radio product is designed to comply with the following national
and international standards and guidelines regarding exposure of human beings
to radio frequency electromagnetic energy (EME):
Your wireless phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radiofrequency
(RF) energy set by the Federal Communications Commission of the U.S.
Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are based
on standards that were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. The standards include a
substantial safety margin designed to assure the safety of all persons, regardless of
age and health.
• United States Federal Communications Commission, Code of Federal
Regulations; 47 CFR part 2 sub-part J.
• American National Standards Institute (ANSI) / Institute of Electrical
and Electronics Engineers (IEEE). C95. 1-1992.
• Institute of Electrical and Electronics Engineers (IEEE). C95. 1-2005
Edition.*
The exposure standard for wireless mobile phones employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6W/kg.
1
Tests for SAR are conducted using standard operating positions
reviewed by the FCC with the phone transmitting at its highest certified power level
in all tested frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the phone while operating can be
well below the maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base station antenna, the
lower the power output.
• International Commission on Non-Ionizing Radiation Protection (ICNIRP)
1998.
• Ministry of Health (Canada). Safety Code 6. Limi ts of Human
Exposure to Radiofrequency Electromagnetic Fields in the
Frequency Range from 3 kHz to 300 GHz, 1999.
• Australian Communications Authority Radio communications
(Electromagnetic Radiation - Human Exposure) Standard 2003.
• ANATEL, Brazil Regulatory Authority, Resolution 303 (July 2, 2002)
"Regulation of the limitation of exposure to electrical, magnetic, and
electromagnetic fields in the
Before a phone model is available for sale to the public, it must be tested and
certified to the FCC that is does not exceed the limit established by the
government-adopted requirement for safe exposure. The tests are performed in
positions and locations (e.g., at the ear and worn on the body) as required by the
FCC for each model. The highest SAR value for this model phone when tested
for use at the ear is
0.32 W/kg
and when tested on the body, as described in this user
guide, i
s 0.45 W/kg during packet data transmission. (Body-worn measurements
differ among phone models, depending upon available accessories and FCC
requirements.)
2
* The information provided in this document supersedes the general safety
information in user’s guides published prior to May 1, 2006
radio frequency range between 9 kHz and 300 GHz." "Attachment to Resolution
303 from July 2, 2002.
While there may be differences between the SAR levels of various phones and at
various positions, they all meet the government requirement for safe exposure.
The FCC has granted an Equipment Authorization for this model phone with all
reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model phone is on file with the FCC and
can be found under the Display Grant section of
http://www.fcc.gov/oet/fccid
after searching on FCC ID IHDT56KQ1.
Additional information on Specific Absorption Rates (SAR) can be found on
the Cellular Telecommunications Industry Association (CTIA) web-site at
http://www.wow-com.com.
1 In the United States and Canada, the SAR limit for mobile phones used by the
public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard
incorporates a substantial margin of safety to give additional protection for the
public and to account for any variations in measurements.
2 The SAR information reported to the FCC includes the FCC-accepted
Motorola testing protocol, assessment procedure, and measurement
uncertainty range for this product.
Operational Precautions
To assure optimal radio product performance and to be sure that human exposure
to RF does not exceed the guidelines set forth in the relevant standards, always
follow these instructions and precautions :
Two-way radio operation
Your radio product has been designed and tested to comply with national and
international standards and guidelines regarding human exposure to RF
electromagnetic energy, when operated in the two-way mode (at the face, or at
the abdomen when using an audio accessory) at usage factors of up to 50%
talk/50% listen.
Transmit no more than the rated duty factor of 50% of the time. To transmit
(talk), push the Walkie-Talkie (WT) button. To receive calls, release the WT
button. Transmitting 50% of the time or less, is important because this radio
generates measurable RF energy only when transmitting (in terms of measuring
for standards compliance).
When using your radio product as a traditional
two-way radio, hold the radio product in a vertical
position with the microphone one to two inches (2.5
to 5 cm) away from the lips.
v
To Next Page
Loading...
