1.To reduce risk of injury, charge only the rechargeable
Motorola authorized batteries listed in Tables 1 through
8. Other batteries may explode, causing personal injury
and damage.
2. Use of accessories not recommended by Motorola may result in
risk of fire, electric shock, or injury.
3. To reduce risk of damage to the electric plug and cord, pull by
the plug rather than the cord when disconnecting the charger.
4. An extension cord should not be used unless absolutely
necessary. Use of an improper extension cord could result in
risk of fire and electric shock. If an extension cord must be used,
make sure that the cord size is 18AWG for lengths of up to 100
feet (30.48m), and 16AWG for lengths up to 150 feet (45.72m).
5. To reduce risk of fire, electric shock, or injury, do not operate the
charger if it has been broken or damaged in any way. Take it to a
qualified Motorola service representative.
6. This unit is repairable.
Each pocket is powered by a unique
printed circuit board & power supply. The PCB / power supply
can be purchased from the Aftermarket / Parts organization.
The PCB replacement part number is RLN5325. No other
component level replacement parts are available. A service
manual describing the replacement process can also be
ordered from the Aftermarket / Parts organization. The Service
Manual Number is 6880309L66.
7. To reduce risk of electric shock, unplug the charger from the ac
outlet before attempting any maintenance or cleaning.
To Next Page
Loading...
