Motorola Mag One Series - Section 4: RADIO PROGRAMMING; Introduction to Radio Programming; Programming and Cloning Radios

Introduction 4-1
Section 4
RADIO PROGRAMMING
1.0 Introduction
The radios can be programmed using the Customer Programming Software (CPS).
2.0 Programming Your Radio
2.1 Overview of the Programming Process
To prepare properly programmed radios for your customers, you should
1. program your radio with all the necessary parameters, as required by your customers, and
then
2. clone these parameters over to all your customer‟s radios.
2.2 Cloning Radio Parameters to User Radios
Cloning duplicates the contents of Radio 1 (master radio) into Radio 2 (slave radio).
2.3 Parameters which are cloned
• Radio Configuration parameters
• Conventional Personality parameters
2.4 Parameters which are not cloned
• Unit Serial Number.
• Model Number
2.5 To Clone a Radio
Cloning duplicates the contents of your radio (master radio) into your customer‟s radio (slave radio).
Tuning and alignment information are not affected by cloning.
2.5.1 Setting Up the Master Radio
1. Turn off the radio.
2. Press and hold Programmable Button 1 (the top programmable button) and turn on the radio.
Keep pressing the Programmable Button 1 until beep is heard twice.
3. Release Programmable Button 1. Notice that the LED changes to RED.