December 2, 2003 6881096C46-O
5-2 CPS Programming:
The Siren/PA Options screen enables you to modify various Siren/PA options (default settings are
indicated). The following tables describe the programmable fields and their settings:
Table 5-1. Public Address Fields
Field Options
Options Audio Muting Disabled (default): Routes all audio to the Public Address speaker when in
External Radio Mode.
Enabled: Prevents deciphered SECURENET® audio and Mobile Voice
Storage message playback from being heard over the external speaker.
PA Ignition Sense Disabled (default): Public Address operable with ignition switch on or off.
Enabled: Public Address operable only with ignition switch on.
Ext Radio Ignition Disabled (default): External Radio operable with ignition switch on or off.
Enabled: External Radio operable only with ignition switch on.
Default PA Volume Level This field is programmed to set the Public Address volume level for initial
power-up. If no volume level is manually selected by the operator, the
volume will default to the setting in this field.
The range is from 0 to 15 (default 11).
Siren P/A After Reset LAST STATE* (default): The siren will power up in the same state, on or off,
as at power-down (Warm Start).
Off: Siren will always be off at power-up.
*Not available in initial offering. See Table 1-1, “Siren/PA Features,” on page 1-2.
Table 5-2. Siren Fields
Field Options
Hi-Lo Airhorn Tones Disabled: Hi-Lo and Airhorn tones cannot be produced.
Enabled (default): Hi-Lo and/or Airhorn tones are allowed.
Manual Tone This field selects the Manual Tone that will be heard when the Horn-Ring is
pressed. The choices are Ar Hn, Wail, or Yelp (default is Wail).
Siren Ignition Sense Disabled: Siren tones operable with the ignition switch on or off.
Enabled (default): Siren tones operable with ignition switch on.
To Next Page
Loading...
Need help?
General