3 Select one of the following options:
• On – You need to confirm the talkgroup selection by pressing Select or pressing the PTT
button to immediately start a call on a new talkgroup.
• Off – Attaches to the selected talkgroup without any additional prompt.
4.7.15
Default Setting
This sub-menu item resets the radio back to default settings.
4.7.15.1
Selecting Default Setting
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Def. Settings.
Your radio display Reset to def. settings?. Press Yes to confirm.
4.8
Group Setup
This menu item allows you to set the operation parameters, scanning and my groups folder.
4.8.1
Setting Operations Parameters
When and where to use: If you want to define the radio mode and the talkgroup at the radio startup,
and when changing modes TMO → DMO and TMO → Repeater.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup → Operations Parameters.
3 Select Startup. Select one of the following options:
• TMO – The radio powers up in TMO mode.
• DMO – The radio powers up in DMO mode.
• Last Selected – The radio powers up in the mode it was in when last powered down.
4 Select Home Group Startup. Select one of the following options:
• Last Selected – The radio enters the TMO/DMO talkgroup which was last selected before
power down.
• Home Group – The radio enters the Home Group (TMO or DMO) at power up, depending on
the radio mode entered at power up.
5 Select HGr TMO → DMO/Rep. Select one of the following options:
• Last Selected – When changing modes the radio enters the DMO Talkgroup last selected,
for example the DMO Talk Group active last time the Radio was in DMO Mode. If Group
Mappings are configured, they will take precedence and the DMO Talkgroup mapped to the
current TMO Talkgroup is used.
68015000585-MF
Chapter 4: Main Menu
103
To Next Page
Loading...
