• Version – Displays detailed information on software version: SW (software version), HW
(hardware version), ASIC (application-specific integrated circuit), RC (release code).
4.16.4
Backlog
This sub-menu allows you to enable/disable, view, and delete backlog reports.
NOTICE: The location report backlog is only available when Local Information Protocol (LIP) is
enabled.
4.16.4.1
Enabling or Disabling Backlog
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Enablement.
3 Select one of the following options:
• On – Activates location report backlog recording.
• Off – Deactivates location report backlog recording.
4.16.4.2
Viewing Backlog Reports
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Reports.
The radio displays the number of backlog reports stored.
4.16.4.3
Deleting All Backlog Reports
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Delete All.
4.17
Packet Data
NOTICE: This feature is a selling feature.
The Packet Data (PD) Service allows you to transfer data in a TETRA system using the Internet
Protocol (IP).
NOTICE:
To transfer data from a standard computer over the air, connect the computer using the data
cable PMKN4104 with your radio. Your service provider has to setup additional applications on
your computer.
68015000585-MF
Chapter 4: Main Menu
117
To Next Page
Loading...
