EasyManua.ls Logo

Motorola MTM800 FuG

Motorola MTM800 FuG
158 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTICE: You can adjust the offset value, with 15 minute steps, up to 14 hours ahead or
behind.
4 Press Done.
4.7.8.7
Setting Automatic Updates for the Time and Date
Procedure:
1 From the home screen, press the Menu key.
2 Select SetupTime & DateSystem Update.
3 Select one of the following options:
Off – All the infrastructure information are ignored. The radio uses internal time and offset.
Time Only – Time displayed is calculated from the offset programmed by your service
provider added or subtracted from the infrastructure time.
Time & Offset – Time and offset are updated after receiving from the infrastructure.
4.7.9
Accessory (Accry) Setup
You can connect IMPRES, CORE, Other, or Secondary accessories to the radio side connector.
If you connect an IMPRES accessory, the radio detects and recognizes the accessory automatically. If
you connect a CORE, Other (for example, a third-party accessory), or Secondary accessory (for
example, an earpiece connected to an RSM), the radio may detect the connection but manual
selection is required at the Accry Setup menu.
NOTICE: The Rear Accessory Connector on mobile radios does not detect accessories even
though it is an IMPRES accessory. Therefore, select the connected accessory from the
Transceiver Accry submenu.
The Accry Setup menu contains the supported accessories, represented by their Model Number as
defined by the related Audio Device Descriptor (ADD). ADD is a set of parameters in the radio that
defines the audio settings, such as gains and filters settings, for each accessory.
IMPORTANT: Do not connect RSMs to both connectors at the same time. To ensure correct
connection, do not press any RSM buttons when connecting the RSM to the radio.
4.7.10
Active Accessory (Accry) Type
This menu item allows you to choose which of the accessory selection mode is active.
4.7.10.1
Selecting the Active Accessory (Accry) Type
When and where to use: Use this menu item to determine which microphone has priority during
Alternating Hot Microphone or Ambience Listening.
Procedure:
1 From the home screen, press the Menu key.
2 Select SetupActive Accessory Type.
3 Select one of the following options:
68015000585-MF
Chapter 4: Main Menu
98

Table of Contents

Other manuals for Motorola MTM800 FuG

Related product manuals