3 Highlight the required device and press Menu/OK. Select Connect/Disconnect.
NOTICE:
Depending on languages installed on the radio, some characters in names of devices
might not be displayed properly.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
4.5.4.2
Managing Devices
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth→Devices.
3 Highlight the required device and press the Menu key.
• Name – shows the name of the device (up to 32 characters long). The name is editable only
if it has not been pre-set by the service provider.
• Type – displays the device type. This menu item cannot be configured.
• Access – defines how the radio behaves during a reconnection attempt after losing
connection to this device:
• Automatic – the radio connects with the device automatically.
NOTICE: On some headsets, you may have to press the "Call" button to trigger
reconnection.
• Ask – the radio asks you for confirmation before connecting with the device.
• Manual – the radio connects with the device manually.
• Never – the radio never connects with the device.
• Delete – deletes the device from the paired devices lists.
4.5.5
Disconnecting All Devices
When and where to use:To disconnect all remote devices connected to your radio.
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth→Disconnect All.
All devices are disconnected.
NOTICE: To disconnect only one device, from the home screen, select
Menu→Bluetooth→Devices, highlight the required device, and press Disconnect.
4.5.6
Setting Indoor Location
NOTICE: Your service provider can enable this feature.
68015000899-FH
Chapter 4: Main Menu
85
To Next Page
Loading...
