4
English
8. For fuse replacement, use only fuses of the same type and rating
listed on the charger label. Replace main fuse with CONQUER VBS
UTE 5A, 250V TIME LAG, 5ØX20 MM only.
Operational Safety Guidelines
• This equipment is not suitable for outdoor use. Use only in dry
locations and conditions.
• Maximum ambient temperature around the charger must not exceed
40 °C (104 °F).
• The radio can be in ON only when the radio is transmitting data
wirelessly, such as using Wi-Fi. Otherwise, turn OFF the radio.
• Connect the charger only to an appropriate power supply as listed in
Table 15.
• The AC outlet to which the power supply is connected should be
close and easily accessible.
• Make sure the power supply cord to the charger is located where it
will not be stepped on, tripped over, or subjected to water, damage,
or stress.
• Connect the power supply only to an appropriately fused and wired
AC outlet with the correct voltage (as specified on the product).
• Disconnect from line voltage by removing the power supply from the
AC outlet.
Supported Models
Table 1: Supported models and description
Model Description
PS000029A01 (UNIV)
PS000029A04 (EU/UK)
PS000029A06 (RK)
1-Display, with Charger Reprogramming and IMPRES 2
Fleet Management
PS000029A02 (UNIV)
PS000029A05 (EU/UK)
PS000029A07 (RK)
6-Display, with Charger Reprogramming and IMPRES 2
Fleet Management
PS000029A03 (EU/UK)
PS000029A08 (RK)
6-Display, with Charger Reprogramming, IMPRES 2 Fleet
Management, and USB Accessory Charging
MN002407A01.book Page 4 Thursday, February 16, 2017 3:18 PM
To Next Page
Loading...
Need help?
General
