22
calls
A Hub may consist of 1 to 4 Talkgroups*. One
of the four Talkgroups is preset as primary and
the other three as secondary.
If you turn on the Scan feature and your
handset is idle, it will monitor the activity of
up to four Talkgroups in the same way.
That is, the handset checks for all four
Talkgroups in every group call request that it
receives from the system. If the Group ID in
the group call request matches any of the four
Talkgroups the handset is monitoring, it
responds with a group call response and
attempts to join the call. The handset can
initiate a group call on the primary Talkgroup,
and respond to a group call on any of the
three secondary Talkgroups.
*Service provider dependent
With Scan on, all group calls you make are
Hub calls. Group calls you receive are Hub
calls or Talkgroup calls to Talkgroups in the
Hub you have joined.
assign a knob position to a
Talkgroup or MOTOtalk
Note:
First create a set as explained on page
25.
1
From the main menu, select
Settings > 2-
Way Radio > Knob Position
.
2
Scroll to the knob position for assignment
and press .
3
Choose an option from the following list
and press :
OK
r765_Armadillo.book Page 22 Wednesday, August 27, 2008 7:01 PM
To Next Page
Loading...
