Motorola Razr V3x Personalization Guide (MoGu V3xPG) V2.5
(Volume 1 - Primary Mods)
V3X Personalization Guide-V2-5-eb-v1-061205.doc 155 of 227
ebentley
w that that's done, open the
el that's highlighted. In this
, the value "30" is currently s
een it says "Adr. hex: 1D
t address decreases, move to the right and it increases in
No SEEM "0032_0001" that you just saved. In this screen shot, look at the value in the white
pan case the number "30" is seen in blue. This is the actual offset location that must be edited.
So tored in offset "1D". How do we know that this is offset "1D"? Notice at the bottom of the
scr ". This will change based on what offset square you are highlighting. Move to the left and the
offs number. To navigate around to other offsets either click with
your mouse or use your arrow keys of do it the easy way and go to the top menu and click address>go to. Then type in the
address and reen.
e
XVI32 will go to that specific address. You can verify the address on the bottom of the sc
to the tool bar menu. Click "Tools"
Go and then "Bit manipulation...".
To Next Page
Loading...
Need help?
General
