Motorola Razr V3x Personalization Guide (MoGu V3xPG) V2.5
(Volume 1 - Primary Mods)
V3X Personalization Guide-V2-5-eb-v1-061205.doc 156 of 227
ebentley
Th a bit. Depending on the SEEM you are editing,
you will either check or uncheck the corresponding box next to the bit. After that, click the "Set" button and save the edited
SE
gui have to do is find the offset "22" and then manually type "01" in its two-digit box. You do not go into the
bit manipulator to do this.
Ve
e "Bit manipulation" window pops up. Each value from "0" to "7" is called
EM "0032_0001". If you get SEEM editing instructions like: "004a_0001 > offset 22 [Set 01]" somewhere outside of this
de, then all you
rify everything you do.
w upload the saved SEEM "0032_0001" using P2K Phone File Manager. Go to the "SEEM" area. This time use the
er two boxes where it says "Upload SEEM". Type in "0032" in the "SEEM" box and "0001" in the "rec" box as shown
en click the "Upload SEEM" button.
No
low .
Th
he "Open" window choose the SEEM "0032_0001" and click the "Open" button.
In t
To Next Page
Loading...
Need help?
General
