RFS4010 RF Switch: Installation Guide
2
1.3 Warnings
• Read all installation instructions and site survey reports, and verify correct equipment installation before connecting
the system to its power source.
• Remove jewelry and watches before installing this equipment.
• Install the equipment in a rack or on a desktop with adequate dimensions and weight allowances.
• Verify the unit is grounded before connecting it to the power source.
• Verify any device connected to this unit is properly wired and grounded.
• Connect all power cords to a properly wired and grounded electrical circuit.
• Verify the electrical circuits have appropriate overload protection.
• Motorola strongly recommends the use of an Uninterruptible Power Supply (UPS) that supports the RFS4010 RF
Switch power rating. Not using a UPS can result in data loss or equipment damage due to a power surge or power
failure.
• Verify that the power connector and socket are accessible at all times during the operation of the equipment.
• Do not work with power circuits in dimly lit spaces.
• Do not install this equipment or work with its power circuits during thunderstorms or other weather conditions that
could cause a power surge.
• Verify there is adequate ventilation around the device, and ambient temperatures meet equipment operation
specifications.
• This product is designed for in building installation only and is not intended to be connected to exposed (outside
plant) networks.
1.4 Site Preparation
• Consult your site survey and network analysis reports to determine specific equipment placement, port capacity,
power drops, and so on.
• Assign installation responsibility to the appropriate personnel.
• Identify where all installed components are located.
• Verify appropriate rack mounting requirements, as required.
• Provide a sufficient number of power drops for your equipment.
• Ensure adequate, dust-free ventilation to all installed equipment.
• Identify and prepare Ethernet and console port connections.
• Verify that cable lengths are within the maximum allowable distances for optimal signal transmission.
• Verify that the RFS4010 RF Switch is powered through an Uninterruptible Power Supply (UPS).
WARNING!
Indicates a condition or procedure that could result in personal injury or
equipment damage.
To Next Page
Loading...
Need help?
General
