SB5100 Series Cable Modem User Guide 21
Introduction Before You Begin Installation & Configuration FAQ
Troubleshooting
Glossary
License
Setting Up a USB Driver in Windows XP
Be sure the SURFboard Cable Modem CD-ROM is inserted into the CD-ROM drive
before you plug in the USB cable. A few seconds after you complete the USB
connection, the Found New Hardware Wizard window is displayed.
1 Be sure “Install the software automatically” is selected.
2 Click Next. Windows automatically searches for the correct USB drivers and installs
them. If the installation is successful, the window at bottom left is displayed.
3 Click Finish to complete the installation. Otherwise, be sure the SURFboard Cable
Modem CD-ROM is correctly inserted in your CD-ROM drive.
When you finish setting up the USB driver, you can continue with “Configuring TCP/IP in
Windows XP” on page 30.
.
Although your SURFboard cable modem model number may
be different than in the images in this guide, the procedure is
the same.
To Next Page
Loading...
