SB5100 Series Cable Modem User Guide 22
Introduction Before You Begin Installation & Configuration FAQ
Troubleshooting
Glossary
License
Configuring TCP/IP
The SURFboard cable modem contains all required software. You do not need to
configure the cable modem, but you must be sure that your computer is configured for
TCP/IP (a protocol for communication between computers). Perform one of:
• “Configuring TCP/IP in Windows 95, Windows 98 SE, or Windows Me” on page 23
• “Configuring TCP/IP in Windows 2000” on page 26
• “Configuring TCP/IP in Windows XP” on page 30
• Follow the instructions in your Macintosh or UNIX user manual
After configuring TCP/IP, perform one of the following to verify the IP address:
• “Verifying the IP Address in Windows 95, Windows 98 SE, or Windows Me” on
page 37
• “Verifying the IP Address in Windows 2000 or Windows XP” on page 38
• Follow the instructions in your Macintosh or UNIX user manual
Your cable service provider may provide additional instructions to set up your computer.
To Next Page
Loading...
Need help?
General