Configuring TCP/IP in Windows 95, Windows 98 SE, or
Windows Me, continued
Introduction Before You Begin Installation & Configuration FAQ
Troubleshooting
Glossary
License
SB5100 Series Cable Modem User Guide 25
10 Click TCP/IP on the Network window. If there is more than one TCP/IP entry, choose
the one for the Ethernet card or USB port connected to the cable modem.
11 Click Properties. The TCP/IP window is displayed.
12 Click the IP Address tab.
13 Click Obtain an IP address automatically.
14 Click OK to accept the TCP/IP settings.
15 Click OK to close the Network window.
16 Click OK when prompted to restart your computer and click OK again.
When you complete TCP/IP configuration, go to “Verifying the IP Address in Windows 95,
Windows 98 SE, or Windows Me” on page 37.
To Next Page
Loading...
