5-22 Disassembly/Reassembly Procedures: Radio Reassembly – Detailed
6. Fasten the battery door latch as shown in Figure 5-32.
Figure 5-32. Latching battery door
7. Attach the antenna to the radio as shown in Figure 5-33.
Figure 5-33. Antenna reassembly
8. Using a torque wrench, screw in the antenna screw with the 4IP Torx Plus screwdriver as shown
in Figure 5-34.
NOTE
a. The antenna must be fully inserted before screwing in the antenna screw.
b. Ensure that there is no gap between the antenna and the housing.
To Next Page
Loading...
