6809495A77-O September 23, 2005 29
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Front Housing
1. Remove the battery cover, battery, SIM, antenna, and transceiver PC board as
described in the procedures.
2. Insert the disassembly between the front housing and the chassis assembly
(see Figure 15).
3. Slide the disassembly tool around the phone between the front housing and
the phone to release the housing catches along the sides of the front housing
(see Figure 15).
4. Carefully lift and remove the front housing from the phone.
5. To replace, align the front housing to the phone.
6. Lower the phone onto the front housing and keypad.
7. Carefully and gently press the front housing into the chassis until all of the
housing catches are engaged.
8. Reassemble the transceiver PC board, transceiver PC board shield, antenna
cap, SIM, battery and battery cover as described in the procedures.
050976o
Figure 15. Releasing the Front Housing Catches
Disassembly tool
Front housing
To Next Page
Loading...
