2.3
Attaching the Antenna
Prerequisites: Ensure the radio is turned off before attaching the antenna.
Procedure:
1. Set the antenna in the receptacle.
2. Turn the antenna clockwise to attach to the radio.
3. To remove the antenna, turn the antenna counterclockwise.
NOTE: When removing the antenna, ensure that the radio is turned off.
2.4
Removing and Attaching the Accessory Connector
Cover
The accessory connector is on the antenna side of the radio. It is used to connect accessories to the radio.
NOTE: To prevent damage to the connector, shield it with the connector cover when not in use.
Procedure:
1. To remove the accessory connector cover, rotate the thumbscrew counterclockwise until it disengages
from the radio.
NOTE: If the thumbscrew is too tight, use an allen wrench to loosen it.
2. Rotate and lift the connector cover to disengage it from the radio.
3. Slide the accessory connector cover over the antenna and position at the base of the antenna.
4. To attach the accessory connector cover, insert the hooked end of the cover into the slot above the
connector.
5. Press the top of the cover downward to seat it in the slot.
6. Tighten by rotating the thumbscrew clockwise by hand.
2.5
Using the Carry Holder
Procedure:
1. Position the radio within the carry holder with the main speaker facing outward.
2. Slide the radio down into the carry holder until it clicks in place.
3. To remove the radio from the carry holder, place the tip of your fingers on the ledge of the carry holder.
4. Push at the bottom of the radio until the radio is released from it.
68012005050-FY
Chapter 2: Getting Started
19
To Next Page
Loading...
