7.10.3
Exiting Fall Alert
Procedure:
To exit Fall Alert mode, press Clr.
7.10.4
Reinitiating Fall Alert
Procedure:
To reinitiate Fall Alert after exiting Emergency Operation, perform one of the following actions:
● Return the radio to a vertical position.
● If motion sensitivity is enabled, shake the radio.
7.11
Secure Operations
Secure radio operation provides the highest commercially available level of voice security on both trunked
and conventional channels.
7.11.1
Selecting Secure Transmissions
Procedure:
Turn the preprogrammed Secure/Clear switch to the secure position.
● If the selected channel is preprogrammed for clear-only operation, when you press the PTT button,
you hear an invalid mode tone and the display shows CLR TX.
● The radio does not transmit until you set the Secure/Clear switch to the clear position.
● If the “Ignore Secure/Clear Switch when Strapped” programming option is enabled, the radio
transmits without displaying any messages in the strapped mode of operation, regardless of the
Secure/Clear switch setting. This option must be preprogrammed by a qualified radio technician.
● The Secure/Clear switch only applies when the radio is transmitting.
7.11.2
Selecting Clear Transmissions
Procedure:
Turn the preprogrammed Secure/Clear switch to the clear position.
● If the selected channel is preprogrammed for secure-only operation, when you press the PTT button,
you hear an invalid mode tone and the display shows SEC TX.
● The radio does not transmit until you set the Secure/ Clear switch to the secure position.
● You can request to configure the radio to ignore the clear voice or insecured transmission when the
radio is in secured transmission. Check with your agent for details.
68012005050-FY
Chapter 7: Advanced Features
58
To Next Page
Loading...
