Motorola SRX 2200 - Trunking System Controls

7.14.3
Entering Mission Critical Geofence
When and where to use:
When the radio enters the predefined Geofence area, the radio displays <Geofence Alias> with the
intelligent backlight and you hear a Voice Announcement. Zone and channel alias of the Geofence area is
displayed. If the radio is set to manual, you can choose either to proceed with zone and channel change or
cancel the change.
The radio then connects to the designated talkgroup. The radio displays the talkgroup alias and dynamic
regroup tone sounds. The transmit power level changes and the radio shows a direct text message content
without any user operation.
NOTE:
The availability of the Voice Announcement (VA), TMS display, Intelligent Backlight, and Transmit
Power Level alerts depend on your radio configuration. The VA can be programmed to alert
continuously or momentarily.
If Site Selectable Alert (SSA) is enabled, the radio mutes any alert that is received when entering the
Geofence area and unmutes when exiting.
7.14.4
Exiting Mission Critical Geofence
When and where to use:
When the radio exits the Geofence area, the radio reverts to the original transmit power level,
intelligent lighting, channel, or newly assigned talkgroup. Voice announcement is canceled or you hear a
preprogrammed VA tone. The radio displays the new channel and a message is received to indicate the
changes.
7.15
Trunking System Controls
This chapter explains the trunking system control features in your radio.
7.15.1
Operating in Failsoft System
When and where to use:
The failsoft system ensures continuous radio communication during a trunked system failure. If a trunking
system fails completely, the radio goes into failsoft operation and automatically switches to its failsoft channel.
During failsoft operation, your radio transmits and receives in conventional operation on a predetermined
frequency. You hear a medium-pitched tone and the display shows FAILSOFT.
When the trunking system returns to normal operation, your radio automatically leaves failsoft operation and
returns to trunked operation.
To continue in Failsoft and to communicate with other talkgroups, refer to the following procedure.
Procedure:
1. Rotate the 16–Position Select Knob to change to a different repeater frequency.
2. Press the PTT button to talk, and release the button to listen.
68012005050-FY
Chapter 7: Advanced Features
64