If the upgrade happens on the ASTRO 25 and ASTRO Conventional systems, the upgrade pauses to give
priorities to voice call, and continues after the voice call ended. If the upgrade happens on a Wi-Fi network,
the upgrade process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio, you can install new changes immediately, or delay
changes to be installed on the radio when it is being powered up.
Your radio can also be configured to allow you to accept or reject an upgrade.
7.17.1
Responding to the Notification of Upgrade
When and where to use: If a configuration upgrade is downloaded to your radio, an alert tone sounds and
the upgrade is installed at the next radio power up. If a firmware upgrade is downloaded to your radio, an
alert tone sounds and the display shows UPGRADE.
Procedure:
To accept the upgrade, long press the Top Side (Select) button within 15 seconds of UPGRADE appearing
on the display.
NOTE: Do not remove the power cable or power down the radio during the firmware upgrade
process.
The radio resets and the installation take several minutes.
NOTE: The radio cannot be used while the upgrade is being installed. Therefore, make sure to only
accept the upgrade at a convenient time when immediate radio use is not required.
If the Top Side (Select) button is not long pressed within 15 seconds, the UPGRADE display is cleared
until the next radio power up.
7.18
Voice Announcement
This feature enables the radio to audibly indicate the current feature mode, zone, or channel assigned to the
user.
The available voice announcement (VA) priority options are:
High
Voice announcement is enabled even when the radio is receiving calls.
Low
Voice announcement is disabled when the radio is receiving calls.
NOTE: If the Voice Announcement field is set to Enabled, after an interruption by a momentary tone
one of the following scenarios occurs:
● If Suppress Replay field is Enabled, voice announcement replays.
● If Suppress Replay field is Disabled, voice announcement turns off.
7.19
Site Selectable Alerts (ASTRO 25 Trunking)
A Site Selectable Alert (SSA) is an Intelligent Lighting indicator with audio alert. The alert is sent to radios at
sites to notify the users when special situations occur.
68012005050-FY
Chapter 7: Advanced Features
70
To Next Page
Loading...
