7.8.4
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch console
must be preprogrammed to use this feature. For more information, contact your system administrator.
Procedure:
Perform one of the following actions:
If… Then…
If the emergency mode is initiated
by other radios,
press and hold the Side Button 1 and press the Emergency
button.
If the emergency mode is initiated
by the Supervisor,
Perform one of the following actions:
● Press and hold the Emergency button.
● Press and hold the Side Button 1, and press the Emergen-
cy button.
● Wait for console to clear emergency.
NOTE: The combinations of the following buttons are supported in your radio:
● Radio Side Button 1 and Top (Orange) button.
● Radio Side Button 1 and accessory Orange button.
● Accessory 1-Dot Button and radio Top (Orange) button.
● Accessory 1-Dot Button and accessory Orange button.
7.8.5
Remote Emergency
The Remote Emergency feature allows you to remotely launch the emergency feature on a target radio.
You can send the Remote Emergency request to radios from recently transmitted or received calls that are
stored. The latest Recent Call List refreshes automatically on your radio.
7.8.5.1
Receiving Remote Emergency
The remote emergency will only be launched if your radio has the emergency enabled. The receiving radio
displays Emergency.
Procedure:
To exit the emergency operation, press and hold the programmed Emergency button.
7.8.5.2
Filtering Remote Emergency Contacts
This feature allows you to filter contacts.
Procedure:
1. Press the programmed Remote Emergency button.
68012005050-FY
Chapter 7: Advanced Features
52
To Next Page
Loading...
