Advanced Data Formatting 15 - 27
Setup Field(s)
Send Data (continued)
Send Next 19 Characters
Send Next 20 Characters
Table 15-2
Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan the
Move Cursor To Character on page 15-28
, then any
printable ASCII character from the
Alphanumeric Keyboard on page
15-87
. This moves the cursor to the position after the matching
character. If the character is not there, the rule fails and ADF tries the
next rule.
15-28
Move Cursor to Start of Data Scan this bar code to move the cursor to the beginning of the data. 15-28
Move Cursor Past a Character This action moves the cursor past all sequential occurrences of a
selected character. For example, if the selected character is ‘A’, then
the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan the
Move Cursor Past
Character on page 15-28
, then select a character from the
Alphanumeric Keyboard on page 15-87
. If the character is not there,
the cursor does not move (i.e., has no effect).
15-28
Skip Ahead “N” Characters Scan one of these bar codes to select the number of positions ahead
to move the cursor.
15-29
Skip Back “N” Characters Scan one of these bar codes to select the number of positions back to
move the cursor.
15-30
Send Preset Value Send Values 1 through 6 by scanning the appropriate bar code. Set
these values using the prefix/suffix values in
Table 7-4 on page 7-19
.
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
15-30
To Next Page
Loading...
