User Preferences & Miscellaneous Scanner Options 5 - 17
Prefix/Suffix Values
Key Category Parameter # P = 63h, S1 = 62h, S2 = 64h
Decimal Value Parameter # P = 69h, S1 = 68h, S2 = 6Ah
You can append a prefix and/or one or two suffixes to scan data for use in data editing. To set a value for a prefix or
suffix, scan a four-digit number (i.e., four bar codes from Appendix D, Numeric Bar Codes) that corresponds to that
value. See the ASCII Character Set values in a host interface chapter (e.g., USB Prefix/Suffix Values on page 9-15,
Prefix/Suffix Values on page 8-19, etc.) for the four-digit codes.
When using host commands to set the prefix or suffix, set the key category parameter to 1, then set the 3-digit
decimal value. See ASCII Character Set values in a host interface chapter for the four-digit codes.
To correct an error or change a selection, scan Cancel on page D-3.
NOTE To use Prefix/Suffix values, Scan Data Transmission Format on page 5-18 must be scanned as well.
Scan Prefix
(07h)
Scan Suffix 1
(06h)
Scan Suffix 2
(08h)
Data Format Cancel
To Next Page
Loading...
Need help?
General
