2 After you hear a tone, speak your command into the accessory microphone.
You can hear three different corresponding voice announcement sounds depending on the status:
•
When your device is connected to a Bluetooth accessory.
• When the Bluetooth connection is on but not connected to any Bluetooth accessory.
• When the Bluetooth connection is off. You can speak your command into the accessory microphone
to turn it on.
12.2
Wi-Fi
Wi-Fi
®
is a registered trademark of Wi-Fi Alliance
®
. You can set up and connect Wi-Fi network to
update your device firmware, codeplug, and Voice Announcement.
12.2.1
Turning the Wi-Fi On or Off
Procedure:
1 Press the Voice Assistant button.
2 After you hear a tone, speak your command into the accessory microphone.
If the Wi-Fi is turned on or off, the voice announcement sounds.
12.2.2
Wi-Fi Status
Initiating the voice command for Wi-Fi status allows you to get the Wi-Fi status for your device as
shows in the following table.
Table 9: Wi-Fi Status and Indications
Wi-Fi Status Indications
Your device is connected to the Wi-Fi network.
• The voice announcement sounds.
•
The LED bar shows the Wi-Fi signal
strength.
Your device Wi-Fi is turned on but there are no
Wi-Fi signals.
• The voice announcement sounds.
• The top and bottom crescent red LEDs
blink twice.
• One-bar LED blinks.
Your device Wi-Fi is turned on, connected to the
Wi-Fi router, but there is no internet connection.
• The voice announcement sounds.
• The top and bottom crescent red LEDs
blink twice.
• The LED bar shows the Wi-Fi signal
strength.
MN009911A01-AA
Chapter 12 : Connectivity
42
To Next Page
Loading...
