6809468A80 September 30, 2003 19
Level 1 and 2 Service Manual Tools and Test Equipment
Tools and Test Equipment
The following table lists tools and test equipment recommended for disassembly
and reassembly of V300/V500 telephones. Use either the listed items or equivalents.
Table 1. General Test Equipment and Tools
Motorola Part Number
1
Description Application
RSX4043-A Torque Driver Used to remove and replace screws
-- #0 Cross Point Screwdriver
Used to remove cross point screws in
the flip assembly
—
Torque Driver Bit T-6 Plus, Apex 440-6IP
Torx Plus or equivalent
Used with torque driver
See Table 7 Rapid Charger
Used to charge battery and to power
device
0180386A82
Antistatic Mat Kit (includes 66-80387A95
antistatic mat, 66-80334B36 ground
cord, and 42-80385A59 wrist band)
Provides protection from damage to
device caused by electrostatic discharge
(ESD)
6680388B67
Disassembly tool, plastic with flat and
pointed ends (manual opening tool)
Used during assembly/disassembly of
device
6680388B01 Tweezers, plastic Used during assembly/disassembly
— Digital Multimeter, HP34401A
2
Used to measure battery voltage
8102430Z04 GSM / DCS Test SIM Used to enable manual test mode
1. To order in North America, contact Motorola Aftermarket and Accessories Division (AAD) at (800) 422-4210 or
FAX (800) 622-6210; Internationally, AAD can be reached by calling (847) 538-8023 or faxing (847) 576-3023.
2. Not available from Motorola. To order, contact Hewlett Packard at (800) 452-4844.
1 and 2
V300/V500
6809468A80
To Next Page
Loading...
