6809468A80 September 30, 2003 39
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Camera Assembly
1. Remove the battery cover, battery, SIM, antenna, rear housing, and
transceiver board assembly, flip assembly cover, and CLI lens cover as
described in the procedures.
1. , and flip display lens as described in the procedures.
2. Unlock the ZIF connector and remove the camera assembly flex connector.
3. Carefully lift the camera assembly and flex out of the flip assembly (see Figure
18).
4. To replace, carefully press the camera assembly into its slot in the flip
assembly.
5. Insert the end of the camera assembly flex cable into its slot in the ZIF
connector on the flip display assembly.
6. Replace the CLI lens cover, flip assembly cover, transceiver board, rear
housing, antenna, SIM, battery, and battery connector as described in the
procedures.
Figure 18. Camera Assembly Removal
Camera Assembly
Flex ZIF Connector
Display Assembly PCB
To Next Page
Loading...
