6809468A80 September 30, 2003 41
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Flip Display Module Assembly
1. Remove the battery cover, battery, SIM, antenna, rear housing, and
transceiver board assembly, flip assembly cover, CLI lens cover, camera
assembly, and motor/vibrator as described in the procedures.
2. Carefully lift the display module assembly out of the flip assembly
(see Figure 20).
3. Use the disassembly tool to release the display lens latch on each side of the
display lens (See Figure 20).
4. Carefully lift the display lens away from the flip assembly.
5. To replace, align the flip display lens to the flip assembly and press the lens
into place until the side latches snap into place.
6. Replace the motor/vibrator assembly, camera assembly, CLI lens cover, flip
assembly cover, transceiver board, rear housing, antenna, SIM, battery, and
battery connector as described in the procedures.
Figure 20. Flip Display Module Assembly
Display Module PCB
Flip Assembly
DIsassembly Tool
To Next Page
Loading...
