6809468A80 September 30, 2003 27
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Transceiver Board Assembly
1. Remove the battery cover, battery, SIM, antenna, rear housing and battery
tray as described in the procedures
.
2. Carefully work the flat end of the disassembly tool under the flex connector
and remove the connector from the transceiver board. See Figure 8.
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
G
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
031834o
Figure 8. Disconnecting the flex from the transceiver board
Flex Connector
To Next Page
Loading...
