Entering Text 41
General Text Entry Rules
Use the keypad to enter letters, numbers, symbols, and other characters with the
tap method. Press the same key repeatedly to cycle through available characters.
(See the “Character Chart”. )
Msg:
CANCEL BROWSE
•
If you do not press a key for two seconds, the character in the block cursor is
accepted, and the cursor moves to the next position.
•
The first character of each sentence is capitalised unless you manually change
it. (Press
down to force the character to lowercase while it is highlighted by
the block cursor.)
Press a number key
to enter text at
flashing cursor
location.
Press a number key
as many times as
necessary to enter
the desired
character.
Press and hold a
number key to
cycle between tap
method and
numeric text entry
mode.
Press
up
or
down
navigation keys to
change character in
block cursor to
uppercase or
lowercase.
Press
left
or
right
navigation keys to
move flashing
cursor to the left or
right in text
message.
To Next Page
Loading...
