Programming Mode
12
PRELIMINARY
k
k
Setting Bandwidth (when FCC allowable)
Make sure k is accessed. Please refer to Programming Mode on page 9.
Setting Manager Lockout
This feature aids in preventing changing of radio settings. All buttons except M and
B, will be unaccessible when ‘Y’ is chosen.
• Make sure k is accessed. Please refer to Programming Mode on page 9.
Assigning Channels to Presets
• Change the setting by pushing the \ until ‘b’ displays.
• Press
[
or
]
to select setting:
Bandwidth is only selectable when flashing.
Either "HI" (high: 25.0 kHz) or "Lo" (low: 12.5 kHz) will display.
• To turn lock on, press \ until f displays.
• Press [ or ] to select setting, ‘Y’ or ‘n.’
• Once turned on, f icon displays after exiting k.
• Make sure k is accessed. Please refer to Programming Mode on page 9.
• Press
[
or
]
to choose desired Channel.
• Press and hold T or S to assign a Channel to that preset button, radio beeps
to confirm.
Note: All of the Channel settings are assigned to that preset button.
K
C
n
6881038B80.book Page 12 Thursday, August 30, 2001 5:33 PM
To Next Page
Loading...
