Movo SUTTON - Important Precautions (Battery & Charger); Battery Gauge and Charger Operation

BROME
User Guide
IMPORTANT PRECAUTIONS
1. BATTERY GAUGE
2. OPERATING THE CHARGER
Batteries must be charged before using the scooter for the first time and should be
recharged after each day use. You will need the scooter and the battery charger.
1. Open the charging socket cover (A) and insert the output connector (C) of the
charger (D) into the socket (B), then plug the AC end of the cable into a 100-240V
electrical outlet.
2. Please check if the Power Light (E) turns Yellow along with the status of the Indicator
(F). 3.Charger Indicator status (F)
Rapidly Blinks Red = Error
Flashes Red =
Standby Steady
Red = Charging
Steady Green =
Fully Charged
4. Please follow the instructions closely for your
own safety. When fully charged, please unplug
the charger in reverse order of Step 1.
5. Troubleshooting the charger:
‧If the Power Light (E) is off, please check if the connection is secure.
Status
Display
Capacity (%)
>80
<8
0
<65
<50
<35
<25
<20
F
E
F
E
F
E
F
E
F
E
F
E
F
E
16
Check battery capacity before driving. Recharge the battery immediately when the red light is
flashing as the remaining power can only keep scooter going for buffering 3km or less
Each country has their own AC power cord.The charging procedure may be different from below. If
you require more details, please contact your authorized dealer. Make sure power switch is in
OFF position and free-wheeling lever is in "D" position. Do not use extension cord to connect
the charger. Do not use other brand charger to charge the scooter.
(A)
Figure 39
(B)
(F)
(E)
(D) (C)